2/23/2024 0 Comments Instaling Advanced Renamer 3.92![]() ![]() It does not show the motherboard temp, only the temps for the first 2 cores, but since the temps on the Dynamix screens aren't labeled, that's OK. ![]() Here's a quick and dirty setup for AMD based boards that use the k8temp driver, most of those with Athlon 64 or FX or Opteron CPU's. Monitoring programs won't work until the needed Should try these commands right now to make sure everything is If you have some drivers built into your kernel, the list above willĬontain too many modules. To load everything that is needed, add this to one of the system ![]() Now follows a summary of the probes I have just done.Ĭhip `ITE IT8718F Super IO Sensors' (confidence: 9)ĭo you want to generate /etc/sysconfig/lm_sensors? (yes/NO): no I was able to install Perl from unMenu, and ran sensors-detect, and it output: You can run sensors-detect, but this requires installation of the perl package to make it run (see inside the PLG file). It looks like you don't have any modules/probes installed at all, which are required for your hardware. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |